DIY: Producer / DJ furniture from carpentry panels, by Jonathan

Related projects
TOSIZE Furniture
New!
Check out our new shelf cabinets 3D configurator
Logo TOSIZE.ie
Start composing right away

Create this project yourself with sheet material cut to size by TOSIZE.ie!

Average

1 minuut

Description

Good furniture is important to be able to work with my producer / DJ equipment. The furniture is designed without legs, so it is virtually floating.

DIY floating desk

I started with a construction drawing, in which I looked carefully where I wanted something and whether that fit. When the wood was inside, I lacquered it three times (transparent). It was vuren hout . I drilled round holes in the wood to allow wires to run through them easily. Then I attached the beam and the brackets to the wall (first cut a small piece off). Then it was the turn of the magazine. A slat attached to the side, so that the top is firmly anchored. Then again attached the brackets and the shelf on it. The wooden spruce beams and battens were later cut to size to the following dimensions:

  • Spruce Planed Round Corner 44x70 mm: 165.0 cm
  • Spruce Planed Right Angle 18x45 mm: 159.4 cm
Because I used brackets instead of a wooden stand, I had a little too much wood.

Custom DJ furniture

165,0 cm x 55,0 cm

How next?

This is a project for inspiration. Because our assortment has changed, (some of) the products are no longer available.


View all sheet materials